What to write on an invoice for heat pump maintenance

A heat pump does two jobs, heating and cooling, so the description should show you checked both, plus the parts only a heat pump has: the reversing valve, defrost controls and auxiliary heat.

Example (demo data). Use only the details that match your own visit.

Short version (fits a line item)

Heat pump maintenance. Replaced air filter, cleaned outdoor coil, cleared condensate drain. Checked heating and cooling modes, reversing valve, defrost controls and auxiliary heat. System operating in both modes at end of visit.

Full version (for the invoice notes or the service report)

Reason for visit: Seasonal heat pump maintenance. Service performed: Replaced the air filter. Rinsed the outdoor coil. Cleared the condensate drain. System checks: Thermostat operation, heating mode and cooling mode, reversing valve, defrost board, sensor and termination, auxiliary/emergency heat, crankcase heater, refrigerant pressures, capacitor, contactor and electrical connections checked. Compressor amps and temperature split recorded in the service record. Recommendations: The capacitor tested lower than its rated value. It is still working. We recommend replacing it, since it tested below its rating. Customer will decide after reviewing the quote.

Fill-in template

Heat pump maintenance. [Work done]. Checked heating mode, cooling mode, reversing valve, defrost controls, auxiliary heat and [other items]. Found: [finding, or "no issues found"]. Recommended: [item] because [finding]. Customer [approved / declined / will decide later].

What a heat pump maintenance description should cover

The heat pump checklist in Tech Gibberish has 30 items. The ones customers most often don't know you checked:

See the full heat pump maintenance checklist.

Keep these separate

Ready to paste it in? How to paste your report into the software you already use.

15 free reports. No credit card.

Start free trial

Built by an HVAC company owner who uses it every day.